HOT SURFACE IGNITOR W/PLUG FOR M1 SERIES NORDYNE FURNACE
Ignitor hot surface for M1 series surfaces.
This ignitor is a replacement for Nordyne / Intertherm #'s FC047- FC047KA- FC047KX- 903110- 9031100....
- Metal mounting bracket (attached)-.
- 2 wires with bullet type connectors-.
- Plastic plug-.
- Round rubber insulator & wire nuts.
This ignitor has been redesigned. It looks different- but the new design installs the same and will have a much longer life.
- Ignitor glows to light flame on burner.
- It's also a flame sensor and will send signal to control board to shut down furnace if no flame is detected.
- Replaces 903110- 632313 & 632313c Attention:
- Do not touch carbide portion of the ignitor.
- Oil from your hands may cause premature failure.